Target Kit - Darth Vader Signals

IMG_2671.jpg
IMG_3029.JPG
IMG_2670.JPG
IMG_2674.JPG
IMG_2671.jpg
IMG_3029.JPG
IMG_2670.JPG
IMG_2674.JPG
sold out

Target Kit - Darth Vader Signals

from 15.00

Assembled target PCBs for our N scale Modern Block Signals and UP Type D Signals. Each target has LED aspects and leads pre-installed.

Please note: pre-production models shown utilize 1.6 mm PCB's, production units will have 0.5 mm thick PCBs for a closer to prototype appearance.

Target Size:
Targets Per Pack:
Add To Cart

Each signal head is composed of:

  • (1) 0.5 mm thick PCB target, pre-assembled with three tiny 0201 LED lights and four pieces of magnet wire.
  • (1) Snow Hood, etched in 0.1 mm Stainless Steel.

There are two signal heads on each fret of boards. that means that if you select the "2 Per Pack" option you'll get ONE fret of TWO boards. The "8 Per Pack" option is FOUR frets totaling EIGHT boards.

There are two different options for the target size. The modern target size reflects most modern day Darth Vader targets at 2' wide. The Type D target reflects signals found especially on the UP in the late 1930s with a target that was 2' 9 1/8" wide.

The targets are easily cut out from the frame using a cut-off wheel in a dremel tool followed by some fine sandpaper to square up the board.

The signals are arranged Green-Yellow-Red from top to bottom. The LEDs are wired common Anode and are 100% compatible with the CESM Signal Controller Board range. The Anode wire is green, while the remaining wires are easily identified using included diagrams/lengths of wires. 

We do not plan to produce the 1-, 2-, and 4-light versions of these signals at any time in the near future...